ZyXEL Communications 200 Series - Manual (Page 785)

Appendix A Log Descriptions
ZyWALL USG 100/200 Series User’s Guide
785
Tunnel [%s] Sending
IKE request
%s is the tunnel name. The device sent an IKE request.
Tunnel [%s] IKE
Negotiation is in
process
%s is the tunnel name. When IKE request is already sent but still
attempting to dial a tunnel.
VPN gateway %s was
disabled
%s is the gateway name. An administrator disabled the VPN gateway.
VPN gateway %s was
enabled
%s is the gateway name. An administrator enabled the VPN gateway.
XAUTH fail! My name:
%s
%s is the my xauth name. This indicates that my name is invalid.
XAUTH fail! Remote
user: %s
%s is the remote xauth name. This indicates that a remote user’s
name is invalid.
XAUTH succeed! My
name: %s
%s is the my xauth name. This indicates that my name is valid.
XAUTH succeed! Remote
user: %s
%s is the remote xauth name. This indicate that a remote user’s name
is valid
Dynamic Tunnel
[%s:%s:0x%x:%s] built
successfully
The variables represent the phase 1 name, tunnel name, SPI and the
xauth name (optional). The phase-2 tunnel negotiation is complete.
Dynamic Tunnel
[%s:%s:0x%x:0x%x:%s]
rekeyed successfully
The variables represent the phase 1 name, tunnel name, old SPI, new
SPI and the xauth name (optional). The tunnel was rekeyed
successfully.
Tunnel
[%s:%s:0x%x:%s] built
successfully
The variables represent the phase 1 name, tunnel name, SPI and the
xauth name (optional). The phase-2 tunnel negotiation is complete.
Tunnel
[%s:%s:0x%x:0x%x:%s]
rekeyed successfully
The variables represent the phase 1 name, tunnel name, old SPI, new
SPI and the xauth name (optional). The tunnel was rekeyed
successfully.
Tunnel [%s:%s] Phase
1 pre-shared key
mismatch
The variables represent the phase 1 name and tunnel name. When
negotiating phase-1, the pre-shared keys did not match.
Tunnel [%s:%s]
Recving IKE request
The variables represent the phase 1 name and tunnel name. The
device received an IKE request.
Tunnel [%s:%s]
Sending IKE request
The variables represent the phase 1 name and tunnel name. The
device sent an IKE request.
Tunnel [%s:0x%x] is
disconnected
The variables represent the tunnel name and the SPI of a tunnel that
was disconnected.
Tunnel [%s] rekeyed
successfully
%s is the tunnel name. The tunnel was rekeyed successfully.
Table 289 IKE Logs (continued)
LOG MESSAGE DESCRIPTION