ZyXEL Communications 200 Series User Manual
Page 218
Chapter 10 Interface
ZyWALL USG 100/200 Series User’s Guide
218
The following table describes the labels in this screen.
Table 56 Interface Wizard: WAN ISP Connection Settings
LABEL
DESCRIPTION
ISP Parameter
This section appears if the interface uses a PPPoE or PPTP Internet connection.
User Name
Type the user name given to you by your ISP. You can use alphanumeric and -
_
@$./
characters, and it can be up to 31 characters long.
Password
Type the password associated with the user name above. Use up to 64 ASCII
characters except the [] and ?. This field can be blank.
Retype
to
Confirm
Type your password again for confirmation.
Nailed-Up Select
Nailed-Up if you do not want the connection to time out.
Idle Timeout
Type the time in seconds that elapses before the router automatically disconnects
from the PPPoE server. 0 means no timeout.
PPTP
Configuration
This section only appears if the interface uses a PPPoE or PPTP Internet
connection.
Base
Interface
This displays the identity of the Ethernet interface you configure to connect with a
modem or router.
Base IP
Address
Type the (static) IP address assigned to you by your ISP.
IP Subnet
Mask
Type the subnet mask assigned to you by your ISP (if given).
Server IP
Type the IP address of the PPTP server.
WAN Interface
Setup
WAN
Interface
This displays the identity of the interface you configure to connect with your ISP.
Zone
This field displays to which security zone this interface and Internet connection will
belong.
IP Address
This field is read-only when the WAN interface uses a dynamic IP address. If your
WAN interface uses a dynamic IP address, enter it in this field.
First DNS
Server
Second DNS
Server
These fields only display for an interface with a static IP address. Enter the DNS
server IP address(es) in the field(s) to the right.
Leave the field as 0.0.0.0 if you do not want to configure DNS servers. If you do not
configure a DNS server, you must know the IP address of a machine in order to
access it.
DNS (Domain Name System) is for mapping a domain name to its corresponding
IP address and vice versa. The DNS server is extremely important because without
it, you must know the IP address of a computer before you can access it. The
ZyWALL uses a system DNS server (in the order you specify here) to resolve
domain names for VPN, DDNS and the time server.
Related Setting
Add this
interface to
WAN_TRUN
K for WAN
load balance.
Select this option to use the interface as part of the default WAN trunk (named
“WAN_TRUNK”) for load balancing. This has the ZyWALL send traffic destined for
the Internet out through this interface. If you want to only allow certain traffic
through this interface, clear this check box and configure policy routes to send
traffic through the interface.
Back
Click Back to return to the previous screen.
Next
Click Next to continue to