ZyXEL Communications 200 Series - Manual (Page 701)

Chapter 43 System
ZyWALL USG 100/200 Series User’s Guide
701
Figure 525 System > Vantage CNM
The following table describes the labels in this screen.
Table 246 System > Vantage CNM
LABEL DESCRIPTION
Vantage CNM Click Advanced to display more configuration fields or click Basic to display fewer
fields.
Enable Select this check box to allow Vantage CNM to manage your ZyWALL.
Server IP
Address/FQDN Enter the IP address or fully qualified domain name of the Vantage server.
If the Vantage CNM server is on a different subnet to the ZyWALL and is behind a
NAT router, enter the WAN IP address of the NAT router here and configure the
NAT router to forward UDP port 11864 traffic to the Vantage CNM server.
If the Vantage CNM server is behind a firewall, you may have to create a rule on
the firewall to allow UDP port 11864 traffic through to the Vantage CNM server
(most (new) ZyXEL firewalls automatically allow this).
Transfer Protocol Select whether the Vantage CNM sessions should use regular HTTP connections
or secure HTTPS connections.
Note: HTTPS is recommended.
The Vantage CNM server must use the same setting.
Device
Management IP Select Auto to have the ZyWALL allow Vantage CNM sessions to connect to any
of the ZyWALL’s IP addresses.
Select Custom to specify the ZyWALL’s IP address that allows Vantage CNM
sessions. Configure the Custom IP field if you select this. You might for example
need to specify the IP address when using a WAN trunk that uses multiple WAN IP
addresses.
Custom IP Specify the ZyWALL’s IP address that allows Vantage CNM sessions. This field
applies when you select Custom in the Device Management IP field.
Keepalive
Interval Set how often the ZyWALL sends a keep alive packet to the Vantage CNM server if
there is no other traffic. The keep alive packets maintain the Vantage CNM server’s
control session.
Periodic Inform
Interval Select this option to have the ZyWALL periodically send “Inform” messages to the
Vantage CNM server.
HTTPS
Authentication When you are using HTTPs, select this option to have the ZyWALL authenticate
the Vantage CNM server’s certificate. In order to do this you need to import the
Vantage CNM server’s public key (certificate) into the ZyWALL’s trusted
certificates.
Vantage
Certificate Select the Vantage CNM server’s certificate. This applies when you enable HTTPS
authentication.