ZyXEL Communications 200 Series - Manual (Page 96)

Chapter 4 Wizard Setup
ZyWALL USG 100/200 Series User’s Guide
96
Figure 35 VPN Express Wizard: Step 2
The following table describes the labels in this screen.
4.8 VPN Express Wizard - Remote Gateway
The Remote Gateway policy identifies the IPSec devices at either end of a VPN tunnel.
Name: Type the name used to identify this VPN connection (and VPN gateway). You may use
1-31 alphanumeric characters, underscores(
_ ), or dashes (-), but the first character cannot be a
number. This value is case-sensitive.
Secure Gateway: Enter the WAN IP address or domain name of the remote IPSec router
(secure gateway). Use 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address and
no domain name.
Table 15 VPN Express Wizard: Step 2
LABEL DESCRIPTION
Name Type the name used to identify this VPN connection (and VPN gateway). You may
use 1-31 alphanumeric characters, underscores(
_ ), or dashes (-), but the first
character cannot be a number. This value is case-sensitive.
Secure
Gateway Enter the WAN IP address or domain name of the remote IPSec router (secure
gateway) to identify the remote IPSec router by its IP address or a domain name. Set
this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address.
Pre-Shared
Key Type your pre-shared key in this field. A pre-shared key identifies a communicating
party during a phase 1 IKE negotiation. It is called "pre-shared" because you have to
share it with another party before you can communicate with them over a secure
connection.
Type from 8 to 31 case-sensitive ASCII characters or from 16 to 62 hexadecimal ("0-
9", "A-F") characters. Precede hexadecimal characters with “0x”.
Both ends of the VPN tunnel must use the same pre-shared key. You will receive a
PYLD_MALFORMED (payload malformed) packet if the same pre-shared key is not
used on both ends.
Next Click Next to continue.