1 configuring ftp, Figure 521 system > ftp, Table 242 system > ftp – ZyXEL Communications 200 Series User Manual
Page 695: To specify from
Chapter 43 System
ZyWALL USG 100/200 Series User’s Guide
695
43.9.1 Configuring FTP
To change your ZyWALL’s FTP settings, click System > FTP tab. The screen appears as
shown. Use this screen to specify from which zones FTP can be used to access the ZyWALL.
You can also specify from which IP addresses the access can come.
Figure 521 System > FTP
The following table describes the labels in this screen.
Table 242 System > FTP
LABEL
DESCRIPTION
Enable
Select the check box to allow or disallow the computer with the IP address that
matches the IP address(es) in the Service Control table to access the ZyWALL
using this service.
TLS required
Select the check box to use FTP over TLS (Transport Layer Security) to encrypt
communication.
This implements TLS as a security mechanism to secure FTP clients and/or
servers.
Server Port
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server
Certificate
Select the certificate whose corresponding private key is to be used to identify the
ZyWALL for FTP connections. You must have certificates already configured in the
My Certificates screen (Click My Certificates and see
for
details).
Service Control
This specifies from which computers you can access which ZyWALL zones.
#
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL’s (non-configurable)
default policy. The ZyWALL applies this to traffic that does not match any other
configured rule. It is not an editable rule. To apply other behavior, configure a rule
that traffic will match so the ZyWALL will not have to use the default policy.
Zone
This is the zone on the ZyWALL the user is allowed or denied to access.
Address
This is the object name of the IP address(es) with which the computer is allowed or
denied to access.
Action
This displays whether the computer with the IP address specified above can access
the ZyWALL zone(s) configured in the Zone field (Accept) or not (Deny).