ZyXEL Communications 200 Series - Manual (Page 461)

Chapter 27 Application Patrol
ZyWALL USG 100/200 Series User’s Guide
461
Figure 367 AppPatrol > Other > Edit
The following table describes the labels in this screen.
Table 142 AppPatrol > Other > Edit
LABEL DESCRIPTION
Enable Select this check box to turn on this policy.
Port Use this field to specify a specific port number to which to apply this policy. Type
zero, if this policy applies for every port number.
Schedule Select a schedule that defines when the policy applies or select Create Object to
configure a new one (see
Chapter 38 on page 619 for details). Otherwise, select
any to make the policy always effective.
User Select a user name or user group to which to apply the policy. Select Create
Object to configure a new user account (see
Section 35.2.1 on page 596 for
details). Select any to apply the policy for every user.
From Select the source zone of the traffic to which this policy applies.
To Select the destination zone of the traffic to which this policy applies.
Access This field controls what the ZyWALL does with packets that match this policy.
Choices are:
forward - the ZyWALL routes the packets.
Drop - the ZyWALL does not route the packets and does not notify the client of its
decision.
Reject - the ZyWALL does not route the packets and notifies the client of its
decision.
Source Select a source address or address group for whom this policy applies. Select
Create Object to configure a new one. Select any if the policy is effective for every
source.
Destination Select a destination address or address group for whom this policy applies. Select
Create Object to configure a new one. Select any if the policy is effective for every
destination.
Protocol Select the protocol for which this condition applies. Choices are: TCP and UDP.
Select any to apply the policy to both TCP and UDP traffic.
Bandwidth
Management Configure these fields to set the amount of bandwidth the application can use.
These fields only apply when Access is set to forward.