ZyXEL Communications 200 Series - Manual (Page 807)

Appendix A Log Descriptions
ZyWALL USG 100/200 Series User’s Guide
807
Interface %s links
down. Default route
will not apply until
interface %s links up.
An administrator set a static gateway in interface but this interface is
link down. At this time the configuration will be saved but route will not
take effect until the link becomes up.1st %s: interface name, 2nd %s:
interface name.
name=%s,status=%s,TxP
kts=%u,
RxPkts=%u,Colli.=%u,T
xB/s=%u,
RxB/s=%u,UpTime=%s
Port statistics log. This log will be sent to the VRPT server.
1st %s: physical port name, 2nd %s: physical port status, 1st %u:
physical port Tx packets, 2nd %u: physical port Rx packets, 3rd %u:
physical port packets collisions, 4th %u: physical port Tx Bytes/s, 5th
%u: physical port Rx Bytes/s, 3rd %s: physical port up time.
name=%s,status=%s,TxP
kts=%u,
RxPkts=%u,Colli.=%u,T
xB/s=%u,
RxB/s=%u
Interface statistics log. This log will be sent to the VRPT server.
1st %s: interface name, 2nd %s: interface status, 1st %u variable:
interface Tx packets, 2nd %u variable: interface Rx packets, 3rd %u:
interface packets collisions, 4th %u: interface Tx Bytes/s, 5th %u:
interface Rx Bytes/s.
Interface %s start
dailing.
A PPP or aux interface started dialing to a server. %s: interface name.
Interface %s connect
failed: Connect to
server failed.
A PPTP interface failed to connect to the PPTP server. %s: interface
name.
Interface %s
connection
terminated.
A PPP or AUX connection will terminate. %s: interface name.
Interface %s
connection
terminated: idle
timeout.
An idle PPP or AUX connection timed out.1%s: interface name.
Interface %s connect
failed: MS-CHAPv2
mutual authentication
failed.
MS-CHAPv2 authentication failed (the server must support mS-
CHAPv2 and verify that the authentication failed, this does not include
cases where the servers does not support MS-CHAPv2). %s: interface
name.
Interface %s connect
failed: MS-CHAP
authentication
failed.
MS-CHAP authentication failed (the server must support MS-CHAP
and verify that the authentication failed, this does not include cases
where the server does not support MS-CHAP). %s: interface name.
Interface %s connect
failed: CHAP
authentication
failed.
CHAP authentication failed (the server must support CHAP and verify
that the authentication failed, this does not include cases where the
server does not support CHAP). CHAP: interface name.
Interface %s is
connected.
A PPP or AUX interface connected successfully. %s: interface name.
Interface %s is
disconnected.
A PPP or AUX interface disconnected successfully. %s: interface
name.
Interface %s connect
failed: Peer not
responding.
The interface’s connection will be terminated because the server did
not send any LCP packets. %s: interface name.
Interface %s connect
failed: PAP
authentication
failed.
PAP authentication failed (the server must support PAP and verify
verify that the authentication failed, this does not include cases where
the server does not support PAP). %s: PPP interface name.
Table 301 Interface Logs (continued)
LOG MESSAGE DESCRIPTION