ZyXEL Communications 200 Series - Manual (Page 808)

Appendix A Log Descriptions
ZyWALL USG 100/200 Series User’s Guide
808
Interface %s connect
failed: Connect
timeout.
A PPPOE connection timed out due to a lack of response from the
PPPOE server. %s: PPP interface name.
Interface %s create
failed because has no
member.
A bridge interface has no member. %s: bridge interface name.
"Interface cellular
Application Error Code
%d\n.
The listed error code (%d) was generated due to an internal cellular
interface error.
"An error [%d]
occurred while
negotiating with the
device in %s. Please
try to remove then
insert the device.
The listed error code (%d) happened when the ZyWALL attempted to
negotiate with the cellular device installed in (or connected to) the
listed slot (%s). Remove and reinstall the device.
"Unable to negotiate
with the device in %s.
Please try to remove
then insert the
device.
The ZyWALL could not negotiate with the cellular device installed in (or
connected to) the listed slot (%s). Remove and reinstall the device.
"Unable to configure
the selected frequency
band to the device in
%s. Please try to
remove then insert the
device.
The ZyWALL failed to set the cellular device installed in (or connected
to) the listed slot (%s) to use the frequency band you configured. The
cellular device may not support the band or you may need to try
removing and reinstalling the device.
"PIN code is required
for inteface
cellular%d. Please
check the PIN code
setting.
The PIN code configured for the listed cellular interface (%d) is
incorrect or missing.
"SIM card has been
successfully unlocked
by PUK code on
interface cellular%d.
You entered the correct PUK code and unlocked the SIM card for the
cellular device associated with the listed cellular interface (%d).
"Incorrect PUK code of
interface cellular%d.
Please check the PUK
code setting.
You entered an incorrect PUK code so you were not able to unlock the
SIM card for the cellular device associated with the listed cellular
interface (%d).
"SIM card of interface
cellular%d in %s is
damaged or not
inserted. Please
remove the device,
then check the SIM
card.
The SIM card for the cellular device associated with the listed cellular
interface (%d) cannot be detected. The SIM card may be missing, not
inserted properly, or damaged. Remove the device and check its SIM
card. If it does not appear to be damaged, try re-inserting the SIM card.
"SIM card of interface
cellular%d in %s is
locked. Please enter
PUK code to unlock.
The SIM card for the cellular device associated with the listed cellular
interface (%d) is locked. This may be because the PIN code was
entered incorrectly more than three times. You need to enter the PUK
code to unlock the SIM card. .
Table 301 Interface Logs (continued)
LOG MESSAGE DESCRIPTION