ZyXEL Communications 200 Series - Manual (Page 784)

Appendix A Log Descriptions
ZyWALL USG 100/200 Series User’s Guide
784
Cannot resolve Secure
Gateway Addr %s for
Tunnel [%s]
1st %s is my ip address. 2nd %s is the tunnel name; When selecting a
matched proposal in phase-1, the engine could not get the correct
secure gateway address.
Could not dial dynamic
tunnel "%s"
%s is the tunnel name. The tunnel is a dynamic tunnel and the device
cannot dial it.
Could not dial
incomplete tunnel "%s"
%s is the tunnel name. The tunnel setting is not complete.
Could not dial manual
key tunnel "%s"
%s is the tunnel name. The manual key tunnel cannot be dialed.
DPD response with
invalid ID
When receiving a DPD response with invalid ID ignored.
DPD response with no
active request
When receiving a DPD response with no active query.
IKE Packet Retransmit When retransmitting the IKE packets.
Phase 1 IKE SA process
done
When Phase 1 negotiation is complete.
Recv Main Mode request
from [%s]
%s is the remote name; When receiving a request to enter Main mode.
Recv Aggressive Mode
request from [%s]
%s is the remote name; When receiving a request to enter Aggressive
mode.
Recv:[SA][KE][ID][CER
T][CR][HASH][SIG][NON
CE][DEL][VID][ATTR][N
OTFY:%s]
This is a combined message for incoming IKE packets
Send Main Mode request
to [%s]
%s is the remote name. The device sent a request to enter Main Mode.
Send Aggressive Mode
request to [%s]
%s is the remote name. The device sent a request to enter Aggressive
Mode.
Send:[SA][KE][ID][CER
T][CR][HASH][SIG][NON
CE][DEL][VID][ATTR][N
OTFY:%s]
This is a combined message for outgoing IKE packets.
Start Phase 2: Quick
Mode
Indicates the beginning of phase 2 using quick mode.
The cookie pair is :
0x%08x%08x /
0x%08x%08x
Indicates the initiator/responder cookie pair.
The IPSec tunnel "%s"
is already established
%s is the tunnel name. When dialing a tunnel, the tunnel is already
dialed.
Tunnel [%s] built
successfully
%s is the tunnel name. The phase-2 tunnel negotiation is complete.
Tunnel [%s] Phase 1
pre-shared key
mismatch
%s is the tunnel name. When negotiating phase-1, the pre-shared key
did not match.
Tunnel [%s] Recving
IKE request
%s is the tunnel name. The device received an IKE request.
Table 289 IKE Logs (continued)
LOG MESSAGE DESCRIPTION