Xylem 19 001 300 R2 Silent Storm VFD Pumping System OMRON Touch Screen Display Manual - Manual (Page 104)

© 2013 Flowtronex
100 Omron Touch-Screen Display
Define the characteristics for your primary pumps (under Primary) and for your pumps when in VFD
Bypass mode (under VFD Byp.). The white boxes are enabling bits that show if the item is enabled or
disabled. As shown on the screen above, a green blocked one (1) indicates the item is enabled and a
zero (0) shows the pump is not enabled.
· /2 Start Pump with Press(ure).
· /3 Start Pump with Flow
· /4 Max(imum) Speed reqd (required) to Start
· /5 Flow Stop
· /6 OverPress Accum (Over-pressure Accumulator) enabled
· /7Skip Combo 1 going down
· /8 *Stop Pump with Pressure--Ignore Filter Flush (See *Note below)
· /9 Start Inhibit (Used on Large Filter Systems with Long Flush Cycles)
· Pressing the value next to any of these registers, automatically opens the calculator/keypad. Enter
a one (1 ) to enable the following characteristics, or a zero (0) to disable. (See also,
Calculator/Keypad .)
· Optionally, press Back to return to the N Register Access screen.
· Press the Main Menu touch key to return to the Main Menu. (See also, Main Menu .)
· Optionally, press the *Note key to view the following note about VFD stations when setting the /8
bit sum: