Xylem 19 001 300 R2 Silent Storm VFD Pumping System OMRON Touch Screen Display Manual - Manual (Page 60)

© 2013 Flowtronex
56 Omron Touch-Screen Display
· Optionally, press the Main Menu touch key to return to the Main Menu. (See also, Main Menu .)
· Optionally, press Back to return to the previous screen.
· Press the down arrow (▼) to display the Accessories page 2 screen.
· N80:11 is the time (in minutes) until the first filter flush, after the first main pump starts. The
default value is 3 minutes.
· N80:12 is the time (in minutes) between flushes. This value is dependent on the quality of your
water, and is normally somewhere between 20 and 180 minutes. 60 minutes is a good starting
point. The cleaner the water, the higher this value can be.
· N80:14 is the filter flush duration. It is a calculated value when using a torpedo or scanner type
filter. If the filter is a brush type filter, this value is a physical time, and has to be exact (normally
between 45 and 60 seconds).
· N80:18 is the flush pulse duration. This is the amount of time the filter flushes and is normally set
to 15 seconds. 30 seconds is the maximum setting. Please contact Flowtronex® Product Support
before setting the value higher than 30 seconds.
· N80: 19 is the flush cycle duration. This is the total cycle time (pulse plus rest time) and is
normally set 20 seconds higher than the flush pulse duration. The rest time allows the pump
station to return to the station setpoint pressure before attempting to flush the next filter.
· Tap the value field next to any of these registers and the calculator/keypad pops-over the screen.
Enter or edit the value. (See also, Calculator/Keypad .)
· Optionally, press the Main Menu touch key to return to the Main Menu. (See also, Main Menu .)
· Optionally, press Back to return to the Register Access screen.
· Press the down arrow (▼) in the bottom right corner of the screen to advance to
Accessories page 3.