Xylem 19 001 300 R2 Silent Storm VFD Pumping System OMRON Touch Screen Display Manual - Manual (Page 112)

© 2013 Flowtronex
108 Omron Touch-Screen Display
· Use the Hexadecimal Equivalent Table to determine the number needed. (See, Check My Inputs
and Outputs .)
· Optionally, press the Main Menu touch key to return to the Main Menu. (See also, Main Menu .)
· Optionally, press Back to return to the previous screen, N Register Access .
· Press the down arrow (▼) in the bottom right corner of the screen to advance to the Output
I/O Data: N50:64 to N50:127 screen. (See also, Changing an Output for information.)
2.16.2 Changing an Output
Just like the inputs, output values start at the top left hand corner (N50:64 cell is highlighted below).
You read the table from left to right and then down to the left-most value on the next line— just like
reading a book. Unused parameters are displayed as FFFF.
Note:
Hexadecimal or "hex" numbering uses a base (radix) of sixteen (see table below).
Programmers uses hex numbers as a way to represent binary numbers. A byte is
represented as two consecutive hexadecimal numbers. When converting numbers,
each digit is considered individually.
· Press the I/O Control Data touch key on the N Register Access screen to take you to the Output
I/O Data: N50:64 to N50:127 screen.
· Click on a value to open the calculation/keypad pop-over. Note that this version of the keypad
shows the alphabetic keys, A through F, needed to enter hex numbers.