Pump priming, Run test, Installation procedures – Xylem IM131R01 AQUAVAR AV II User Manual

Page 29: Screen, Instructions, Warning

Advertising
background image

Pump Priming

Refer to your pump operation manual for instructions on pump priming. You will need to unscrew
the pressure transducer and adapter if you used the pump fill plug for mounting. When priming is
complete, replace the pressure transducer and check for leaks!

Run Test

Instructions

1. Check all wiring.

All motors used with the AQUAVAR controller are
three phase. You will need to check the
direction of rotation of the motor shaft. If you
have followed all of the previous steps carefully,
you should now be ready to apply power to the
AQUAVAR controller unit.

2. Close discharge valve.

Make sure the discharge valve is closed.
Apply power to the AQUAVAR controller. The first
screen appears for 2 seconds and shows the
software version and manufacture date. The
next screen will appear automatically
*If auto start is preprogrammed “ON”, pump will start immediately.

3. Check Power Light

Check the AQUAVAR controller panel. The “power on” light should be illuminated and the
display should say “No Autostart - disable inverter.” If either of these conditions is not
present, turn off all power to the AQUAVAR controller and recheck all connections.

To change the display language on the AQUAVAR controller, press the “ ” key and the up arrow key at the
same time. A scrolling line will appear on the bottom of the screen and tell you which button to push for
the language you want. After selecting the language, press the up arrow to return to the main display.

Note

FAILURE TO DISCONNECT AND LOCKOUT ELECTRICAL POWER AND WAIT
FIVE MINUTES FOR CAPACITOR DISCHARGE BEFORE SERVICING AQUAVAR
CONTROLLER CAN CAUSE SHOCK, BURNS, OR DEATH.

WARNING!

WARNING

Hazardous voltage
can shock, burn or
cause death.

Installation Procedures

DO NOT APPLY POWER TO THE AQUAVAR CONTROLLER OR PUMP UNTIL ELECTRI-
CAL CONNECTIONS HAVE BEEN REVIEWED BY A QUALIFIED ELECTRICIAN AND
MEET ALL APPLICABLE STATE AND LOCAL REQUIREMENTS.

WARNING

Screen

NO AUTOSTART - DISABLE INVERTER

ITT Industries
SW:120

Date: 10/30/00

28

*

Advertising