Xylem IM131R01 AQUAVAR AV II - Manual (Page 61)

Multiple Pump Pump Protection... continued
Instructions
3. Error Reset Turning this control on will
enable the AQUAVAR II controller to retry
its operation five times when a fault
condition occurs. Turning the control to
“off” means that the AQUAVAR II
controller will shut down the first time a
fault occurs.
• Press to advance the display to:
• Use the to select the mode you want.
Returning to normal operation:
4. Hold down the key for 2-3 seconds
until the display changes to:
• Scroll past the next few screens (briefly
touch the key) until you reach:
5. Save the new settings by pressing the
at the same time until the display changes to:
After a moment, the screen will automatically return to the main menu start position.
6. Repeat steps 1 through 5 above for each of the other pumps in the system which
have suction switches or float switches.
60
Programming
ERROR RESET
Screen
SUBMENU ERRORS
*
▼
▼
*
*
SAVE ??? +
SAVE ??? SAVED
▼
▼
▼
▼
“Fatal” errors will always shut down the system the first time.
Note