Xylem IM131R01 AQUAVAR AV II - Manual (Page 3)

2
AQUAVAR II Controller Model _________________ Transducer Model_______________________
AQUAVAR II Serial Number _________________ Transducer Rating_______________________
Date purchased _________________
Purchased from _________________
Pump Model _________________ Software Version _______________________
Pump Code Number _________________
Program Record
Please use the following to record the final values programmed into the AQUAVAR controller after installa-
tion.
Required Value____________________ (select) Level 2____________________________ (%)
Autostart ________________________ (on/off) Intensity 1 _________________________ (%)
Password ________________________ (value) Intensity 2 _________________________ (%)
Window ___________________________ (%) Pressure Increase ___________________ (PSI)
Ramp Hysteresis _____________________ (%) Pressure Decrease___________________ (PSI)
Ramp 1 _______________________ (seconds) Enable Sequence Control______________ (Hz)
Ramp 2 _______________________ (seconds) Switch Interval ___________________ (hours)
Ramp 3 _______________________ (seconds) Optional Value _________________________
Ramp 4 _______________________ (seconds) Synchron Limit _____________________ (Hz)
Max. Frequency _____________________ (Hz) Sychron Window ____________________ (Hz)
Min. Frequency ______________________ (Hz) Pump Address _________________ (# or off)
Config. F Min. __________ (F –>0/F –>F min.) ADC Reference ___________________ (select)
Stop - Delay F Min._______________ (seconds) Freq. Lifting________________________ (Hz)
Sensor Adjust _______________ (out of range) Lift Intensity________________________ (%)
Sensor Curve _____________ (linear/quadratic) Analog out ______________________ (select)
Sensor Range - 20mA=362.6 __________ (PSI) Pressure Unit ____________________ (select)
Mode___________________________ (select) Test Run After__________________ (in hours)
(actuator/controller/multicontroller/synch.) Test Frequency______________________ (Hz)
Regulation Mode _________________ (normal) Conveyor Limit _____________________ (PSI)
Start Value _________________________ (PSI) Delay Time ____________________ (seconds)
Config. Second Value _________________ (off) Error Reset ______________________ (on/off)
Relay Config.__________________ (run motor) Display Contrast_____________________ (%)
Offset Input ____________________________ Lock Function ____________________ (on/off)
Level 1 ____________________________ (%)
AQUAVAR II Controller Owner’s Information Record