Xylem IM131R01 AQUAVAR AV II - Manual (Page 34)

6. Press to advance the display to:
This display shows the last recorded error or
fault encountered by the AQUAVAR controller.
7. Press to advance the display to:
This in the error which occurred before the last
one.
8. Press to advance the display to:
The error before error 2.
9. Press to advance the display to:
The error before error 3.
10. Press to advance the display to:
The error before error 4.
11. Press to advance the display to:
This is the total amount of run time of the
motor. It can be reset using a method
described later.
12. Saving changes
Press to advance the display to:
13. Press and hold down BOTH arrows
at the same time until the display changes to:
This will allow you to save the changes you
have made in the microprocessor memory.
14. After about five seconds the display will
automatically return to:
Push . The AQUAVAR II controller will begin to automatically maintain system pressure at the
point you have selected and the display will show the pressure set point.
Programming
33
▼
▼
*
▼
SAVE ??? +
SAVE ??? SAVED
INVERTER STOP - ON->START
If the AQUAVAR II controller is not maintaining the rating you selected, check the sen-
sor adjustment procedures on page 60 or check rotation again.
Note
▼
▼
ERROR 5
*
*
TOTAL RUN TIME
0000:00
If you have advanced past a window and want to return to it, press and at
the same time to back up.
Note
*
ERROR 1
ERROR 2
*
*
ERROR 3
*
ERROR 4
▼
*