Xylem IM131R01 AQUAVAR AV II - Manual (Page 48)

Programming
Enter the submenu by holding the key.
Enter the password and press the key.
Press the key until you see the screen:
Use the and arrows to change the selection to:
Advance the display with the key to:
Hold the key to enter the submenu.
Press the key to advance to:
Use the arrow keys to change to:
Hold the key to leave the submenu then
advance to:
Press both buttons until the display changes to:
Press the key to advance to:
Use the and arrows to set the first required value.
Close the switch connected to X1-10 and X1-14 to
activate the second set point. The display changes
to:
Use the and arrows to set the second required value.
Advance to the Save window and save all settings.
Two required values are now stored in memory. The active required value is determined by the
switch on X1/10 - X1/14. As noted earlier, this can be a manual or automatic (timer controlled)
switch.
*
▼
▼
*
*
ITT INDUSTRIES
20 PSI
PASSWORD
0066
CONFIG. 2ND REQUIRED VALUE
OFF
CONFIG. 2ND REQUIRED VALUE
INT
The other possibilities (Ext. ADC-1, Ext ADC-U 0-10V, Ext ADC-V 2-10V) involve variable
second values controlled by a second sensor. These are discussed in the next section.
Note
*
*
*
SUBMENU
SEQUENCE CONTROL
SOURCE REQUIRED VALUE
OFF
SOURCE REQUIRED VALUE
ADR1
*
SAVE ??? +
▼
▼
SAVE ??? SAVED
REQUIRED VALUE 1
XXX PSI
*
▼
▼
REQUIRED VALUE 2
INT XXX PSI
▼
▼
SAVE ??? SAVED
47