2 operation / printing, 3 printer settings, 4 maintenance – YSI TruLab 1320P User Manual
Page 15: 1 changing the roll of paper (thermal paper), Operation / printing, Printer settings, Maintenance, Changing the roll of paper (thermal paper)
TruLab pH/ISE 1320
Printer (only TruLab pH/ISE 1320 P)
ba76157e01
03/2014
15
4.2
Operation / printing
Data are only output to the printer if the following requirements are met
Data are transmitted manually or automatically (see section 11.1 O
The printer is switched on (LED illuminated)
There is no USB connection.
4.3
Printer settings
To open the Storage & config menu, press the <ENTER_> key in the measured
value display. After completing the settings, switch to the measured value dis-
play with <M>.
Default settings are printed in bold.
4.4
Maintenance
4.4.1 Changing the roll of paper (thermal paper)
Menu item
Possible set-
ting
Description
System / Printer /
Font size
12x20
8x16
7x16
Select the font size for the printer
A print sample (font of the printer) to
view the available font sizes can be
output with <ON/OFF_>.
System /
Printer /
Print test page
-
The printer prints the meter informa-
tion from the menu, System / Ser-
vice information.
The current printer settings are
used for the printout.
1.
Pull the lever (3) until the lid (4) of the paper compartment opens.
2.
If necessary, remove any remains of the old roll of paper.
3.
Insert the new roll of paper. The start of the paper should poke out of the
paper compartment.
4.
Close the lid (4) of the paper compartment so that it clicks into place.
5.
If necessary, move the printer paper forward with <FEED>.