YSI TruLab 1320P - Manual (Page 68)

Settings TruLab pH/ISE 1320
68
ba76157e01 03/2014
9.1.2 Buffer sets for calibration
You can use the buffer sets quoted in the table for an automatic calibration. The
pH values are valid for the specified temperature values. The temperature
dependence of the pH values is taken into consideration during the calibration.
Limit monitoring With the Limit monitoring function
you define the measured values
whose exceeding is signaled. An
acoustic signal sounds, and at the
same time a message is output to
the USB interface.
You can switch on or off the acous-
tic signal in the System menu (see
section 9.3.1 S
YSTEM , page 75).
Limit monitoring/
pH monitoring
On
Off Switch on or off the limit signaling
device for the pH value.
Limit monitoring/
TP monitoring
On
Off Switch on or off the limit signaling
device for the temperature value.
Limit monitoring/
pH monitoring/
On/
pH upper limit -2 ... 20 Upper limit. A message is output to
the USB interface if it is exceeded.
This menu item is only visible when
the pH monitoring setting is active.
Limit monitoring/
pH monitoring/
On/
pH lower limit -2 ... 20 Lower limit. A message is output to
the USB interface if it is exceeded.
This menu item is only visible when
the pH monitoring setting is active.
Limit monitoring/
TP monitoring/
On/
TP upper limit -5 ... +105 °C Upper limit. A message is output to
the USB interface if it is exceeded.
This menu item is only visible when
the TP monitoring setting is active.
Limit monitoring/
TP monitoring/
On/
TP lower limit -5 ... 105 °C Lower limit. A message is output to
the USB interface if it is exceeded.
This menu item is only visible when
the TP monitoring setting is active.
Reset - Resets all sensor settings to the
delivery condition (see section
9.4.1 R
ESETTING THE MEASUREMENT
SETTINGS , page 76).
Menu item Possible set-
ting Description