YSI TruLab 1320P - Manual (Page 75)

TruLab pH/ISE 1320 Settings
ba76157e01 03/2014
75
9.3 Sensor-independent settings
9.3.1 System
To open the Storage & config menu, press the <MENU/ENTER__> key in the
measured value display. After completing the settings, switch to the measured
value display with <M>.
Default settings are printed in bold.
Menu item Possible set-
ting Description
System / General /
Language Deutsch
English
(further) Selects the menu language
System / General /
Beep On
Off Switches on/off the beep on
keystroke
System / General / Illu-
mination Auto
On
Off Switches the display illumina-
tion on/off
System / General /
Contrast 0 ... 50 ... 100
% Changes the display contrast
System /
General /
Switchoff time
10 min ... 1h
... 24 h Adjusts the switch-off time
System /
General /
Temperature unit
°C
°F Temperature unit,
degrees Celsius or degrees
Fahrenheit.
All temperature values are dis-
played with the selected unit.
System /
General /
Stability control
On
Off Switches on or off the auto-
matic stability control during
measurement
System /
Interface /
Baud rate
1200, 2400,
4800, 9600,
19200 Baud rate of the data interface
System /
Interface /
Output format
ASCII
CSV Output format for data trans-
mission (see section 11 T
RANS -
MITTING DATA (USB INTERFACE ),
page 84)
System / Interface /
Decimal separator Dot (xx.x)
Comma (xx,x) Decimal separator
System / Interface /
Output header Output of a header for Output
format: CSV