YSI TruLab 1320P - Manual (Page 21)

TruLab pH/ISE 1320 Operation
ba76157e01 03/2014
21
Only those displays and functions are available in the active operating mode
that are currently being required.
5.4.2 Measured value display
In the measured value display, open the setting menus with <MENU/ENTER>.
The current functions of the softkeys are shown on the display.
 Use <MENU/ENTER> (short pressure) to open the menu for calibration and
measurement settings for the displayed measured parameter.
 Use <MENU/ENTER__> (long keystroke (approx. 2 s) to open the Storage
& config menu with the sensor-independent settings.
Use the keys of the keypad to carry out further functions such as storage or cali-
bration (see section 5.1.1 K
EYPAD , page 17). These functions are not available
in other operating situations.
5.4.3 Menus and dialogs
The menus for settings and dialogs in procedures contain further submenus.

To select a subelement, use the <><> keys. The current selection is dis-
played with a frame.
 To make further settings, switch to the next higher menu level with
<F1>[Back].
 Use <M> to return to the measured value display.
5.4.4 Elements in menus and dialogs
 Submenus
The name of the submenu is displayed at the upper edge of the frame. Sub-
menus are opened by confirming with <MENU/ENTER>. Example:
Operating
mode Description
Measuring The measurement data of the connected sensor are shown
in the measured value display
Calibration The course of a calibration with calibration information, func-
tions and settings is displayed
Storage in
memory The meter stores measuring data automatically or manually
Transmit-
ting data The meter transmits measuring data and calibration records
to a USB-B interface automatically or manually
Setting The system menu or a sensor menu with submenus, set-
tings and functions is displayed