YSI TruLab 1320P - Manual (Page 84)

TruLab pH/ISE 1320 Transmitting data (USB interface)
ba76157e01 03/2014
84
11 Transmitting data (USB interface)
11.1 Options for data transmission
Via the USB interface you can transmit data to a PC. The following table shows
which data are transmitted to the interface in which way:
Data Control Operation / description
Current
datasets of the
sensors
indicated on
the display Manual  With <F2>/[USB output].
 Simultaneously with every manual
data storage process (see section
10.1 M
ANUAL DATA STORAGE , page
78).
Automatic, at
intervals  With <F2__>/[USB output].
Then you can set the transmission
interval.
 Simultaneously with every auto-
matic data storage process (see
section 10.2 A
UTOMATIC DATA
STORAGE AT INTERVALS , page 79).
Stored mea-
sured values Manual  Displayed dataset with <F2>[USB
output] after calling up from the
storage.
 All datasets with the Output to USB
function.
(see section 10.3.1 E
DITING THE
MEASUREMENT DATA STORAGE ,
page 81).
Calibration
records Manual  Calibration record with <F2>/[USB
output]
(see section 6.2.6 C
ALIBRATION
DATA
, page 38).
Automatic  At the end of a calibration proce-
dure.
The following rule applies: With the exception of the menus, shortly
pressing the <F2>[USB output] key generally outputs the display
contents to the interface (displayed measured values, measure-
ment datasets, calibration records).