Canon EOS D30 - Manual (Page 118)

118
Cleaning the CMOS Imaging Element
5 Select [1: Enable].
● Turn the
〈 〉
dial to select [1: Enable],
then press the
〈 〉
button.
The message “ ” appears on the
LCD panel.
● If “ ” is blinking on the LCD panel, set
the Main Switch to
〈
OFF
〉
and remove the
battery pack. Then repeat the procedure
from Step1.
6 Press the shutter button down
fully.
● The reflex mirror of the camera then flips
up, and the shutter opens.
7 Clean the imaging element.
● Carefully blow any dust off the imaging
element using a commercially available
blower.
8 Finish cleaning.
● Set the Main Switch to
〈
OFF
〉
.
The camera power turns off, the shutter
closes and the mirror is lowered.
● Set the Main Switch to
〈
ON
〉
again, and the
camera will be ready to shoot pictures
normally.
● Never disconnect the camera power during cleaning. If the power is cut off, the
shutter will close and possibly damage the shutter curtain.
● Use a blower without a brush attached. Using a brush to remove dust from the
image element can damage the element.
● Do not insert a dust blower into the camera beyond the lens mount. If the power
shuts off and the shutter closes, this may damage the shutter curtains.
● Never use cleaning sprays or blower sprays. The pressure and freezing action
of the spray gas may damage the surface of the imaging element.