B&K Precision 2516 - Manual - Manual (Page 118)

118
4.3 Make Resistance Measurements
To measure resistances, press repeatedly until Meter is set to
“Res.”.
Table 45 – Resistance Measurement Menu
Menu Option Setting Description
Relative
On
Save the current input value as a reference
value. Subsequent measurements will be the
difference from the reference value. This is
same as “zeroing” the meter.
Off Relative mode is disabled.
Auto Select to enable autoranging.
Manual Select to enable manual ranging.
V
Display measurement in volts (V). In manual
ranging, only the volts (V) ranges are
selectable.
mV
Display measurement in millivolts (mV). In
manual ranging, only the millivolts (mV) ranges
are selectable.
Trend Plot
Enters the Meter Trend plot mode (See “Meter
Trend Plot” for more information).
Configure all settings from the menu.
When set for Manual ranging (select Manual by toggling ), use the
key to increase the range. At the highest range, pressing this will
automatically go back to the lowest range.
Resistance ranges: 600 Ω, 6 kΩ, 60 kΩ, 600 kΩ, 6 MΩ, and 60 MΩ.