B&K Precision 2516 - Manual - Manual (Page 143)

143
7 Troubleshooting Guide
System Message Prompts and Instructions
 Trig level at limit!
The trigger level is at the limit when you adjust the trigger level.
 Horizon position at limit!
The horizontal position is at the limit when adjust the horizontal
position keys.
 Volts/Div at limit!
The vertical voltage scale has reached the Minimum 5mV/div or the
Maximum 100V/div.
 Volts position at limit!
The vertical position is at the limit when adjusting the vertical
position keys.
 Sec/Div at limit!
The Volts/Div is at maximum range while turning the vertical scale
keys.
 Holdoff time at limit!
The holdoff time is set to the maximum or minimum value.
 Function isn’t useable!
The selected function cannot be used with the current setup.
 No signal!
Signal could not be found using the key.
 Adjust at limit!
Pulse width has reached the limit (Min 20.0 ns or max 10.0 s).
 Location Empty!
If you have no stored waveforms or setups on the selected location,
the screen will display this information when you press the “Recall”
button on this location.
 USB Flash Drive Plug In!
A USB flash drive is detected and connected to the USB Host port.
 USB Flash Drive Pull Out!
A USB flash drive has been removed.
 Store Data Success!