B&K Precision 2516 - Manual - Manual (Page 136)

136
Meter Trend Plot
Meter Trend Plot allows storing of measurement data and plotting it into a
graph when in multimeter mode. The data can be stored into external
memory using a USB flash drive connected to the USB host port.
To enable this function, there are two ways.
1.
Press the
button from the front panel to enter the
multimeter mode. Then select Trend Plot by pressing .
2.
Press the
button and select Meter Trend Plot by pressing
.
NOTE:
The measurement function (i.e. DCV, ACV, Diode,
etc.) that the meter trend plot will store and plot
depends on the function configured within the
multimeter mode. Therefore, it is important to
set up the multimeter first with the measurement
function you want to use with trend plot.
By default, the trend plot will continuously store and plot data when you
enter the Meter Trend Plot menu.