Record data with trend plot – B&K Precision 2516 - Manual User Manual
Page 139
139
Record Data with Trend Plot
Follow these steps to record data using Meter Trend Plot.
1.
Select the multimeter measurement function you want to record.
Press
to enter the multimeter mode. Then configure the
multimeter for the function you want to measure (follow
instructions from chapter 4 “Using the Digital Multimeter”).
2.
Select the sampling rate at which you want to record and plot the
measurement data.
Press
to toggle the available sampling rate. 10 Sa/s is the
maximum and 0.2 Sa/s is the minimum rate.
Pause Recording
By default, data is always recording continuously. To stop recording at any
time, press
to toggle between Run and Stop.
Restart Recording
To restart recording the data from the beginning, press
to select
Restart. The recording timer will reset back to 0:00:00 and all previously
recorded data will be cleared from memory.
Select Display Mode
The display settings on the trend plot can be changed. Users can select
viewing the data up to the minute, or select viewing all data in a
compressed format.
To toggle between the two display modes, toggle
to select
between Normal and View All.