B&K Precision 2516 - Manual - Manual (Page 144)

144
File successfully saved.
 Ready Data Success!
Setup data or waveform data from the internal storage of the
oscilloscope or USB flash drive was read successfully.
 Record Wave Success!
This message will appear when you finish recording waveforms.
Frequency Asked Questions
Oscilloscope
1.
I pressed the auto button, but it says no signal. Is it malfunctioning?
The auto function does not work for all waveforms. Usually,
waveforms that are periodic can be detected.
2.
How do I adjust the trigger level?
The and keys are used to adjust trigger level.
However, if you select a menu option that has a symbol,
trigger level cannot be adjusted until you exit the menu or select a
different menu option that does not require the use of the same
keys as the trigger level adjust.
3.
There is no Single button, how do I perform a single trigger capture?
Press to enter the Trigger menu, and set Mode to Single.
Then, use button to reset for each single capture.
4.
How do I enter SCAN mode?
SCAN mode is available for timebase settings from 100 ms up to 50
s and is automatic. It is not available for timebase settings below
100 ms.