B&K Precision 2516 - Manual - Manual (Page 29)

29
WARNING:
Only use the supplied external AC adapter. Using a
different or incorrect type adapter will result in
damage to the instrument and void its warranty.
Battery Operation
The instrument can be powered by an external Li-ion battery pack, rated for
5000 mAh, 7.4 V. The battery must be installed and charged before first
time use for battery operation.
Installing the Battery
1.
Use a screw driver to remove the two screws securing the battery
cover in the rear panel.
2.
Connect the 2-pin connector of the battery to the 2-pin input
connector on the lower left corner of the battery compartment.
3.
Place the battery pack inside the compartment and place the battery
cover. Fasten the two screws to tighten.
Figure 9 - Installing Battery
Battery
Battery
1 2 3