BEI Sensors MHK5 Absolute Hollow Shaft Encoder - Manual (Page 4)

Version 07/10 BEI Sensors CANopen Manual serie M 4
General Security Advise
Important Information
Read these instructions carefully, and look at the
equipment to become familiar with the device
before trying to install, operate, or maintain it.
The following special messages may appear
throughout this documentation or on the
equipment to warn of potential hazards or to call
attention to information that clarifies or simplifies
a procedure.
The addition of this symbol to a
Danger or Warning safety label
indicates that an electrical hazard
exists, which will result in personal injury if the
instructions are not followed.
This is the safety alert symbol. It is
used to alert you to potential
personal injury hazards. Obey all
safety messages that follow this symbol to avoid
possible injury or death.
Please Note
Electrical equipment should be serviced only by
qualified personnel. No responsibility is assumed
by BEI Sensors for any consequences arising
out of the use of this material. This document is
not intended as an instruction manual for
untrained persons.
About this Manual
Background
This user manual describes how to install and
configure an absolute rotary encoder with
CANopen interface.
Relate Note
Version date: 14. July 2010
Version number: 1.1
Reference number: MBL20100714
Copyright
The company BEI Sensors claims copyright on
this documentation. It is not allowed to modify, to
extend, to hand over to a third party and to copy
this documentation without written approval by
the company BEI Sensors. Nor is any liability
assumed for damages resulting from the use of
the information contained herein. Further, this
publication and features described herein are
subject to change without notice.
User Annotation
BEI Sensors welcomes all reader to send us
feedback and commands about this document.