IAI America ACON-CY - Manual (Page 86)

74
5. Operation Using I/O Signals
5.4 Power-saving Mode at Standby Positions
In situations where the actuator remains standstill for a long time at a standby position, this controller provides a
mode to reduce power consumption in such standstill state as part of the controller’s energy-saving function.
Use this mode after confirming that it will not cause problems in any part of the system.
The actuator is standing by upon completion of positioning to the target position set in the “Position” field
under each position number
In this case, you can select the desired mode based on the value set in the “Standstill mode” field of the
position table.
(The setting of Parameter No. 53 is ignored.)
Meaning of the setting in the “Standstill mode” field of the position table
Setting
Power-saving mode is disabled. (The actuator is completely stopped.) 0
Automatic servo-off mode. The delay time is defined by Parameter No. 36. 1
Automatic servo-off mode. The delay time is defined by Parameter No. 37. 2
Automatic servo-off mode. The delay time is defined by Parameter No. 38. 3