IntelliTrack WMS – Warehouse Management System - Manual (Page 25)

Chapter 2
Device Setup
15
Overview
In conjunction with the RF Server, terminal emulation allows your WMS
RF application to connect to a portable Windows CE and CE.NET device.
Prior to transferring data between the desktop computer and a portable CE
or CE.NET device, it is essential to establish the correct CE or CE.NET
device portable settings.
For complete RF terminal emulation setup, please refer to the IntelliTrack
RF Terminal Emulation Guide, which is available at the IntelliTrack web-
site (
www.intellitrack.net ) from the Documentation Downloads page.
Note: To enable terminal emulation with the RF Server, select the Line-
Mode Telnet Support option in the RF Server Options form/Utilities tab.
Also, If you use a firewall: The WMS RF Server application must be added
as an exception. A port for the portable devices must be added: since you
are using Windows CE devices with Telnet, add TCP Port 23. (This is an
advanced network setting. Please consult your network administrator
before applying any firewall exceptions.)
Configuring LXE® with WMS RF
The WMS RF application may be used with a LXE® MX3-CE device
(Windows CE 3.0) by using the LXE RFTerm application with the LXE
device. In order for it to work together properly, you must configure the
LXE RFTerm application as outlined in the steps below.
1. Install the RFTerm.cab file on the LXE MX3-CE terminal.
Note: If it is already installed, make sure you have version RFTRM-
PCE.1Hd or higher and the build is 20040621.1Hd or higher.
2. Open the RFTerm application on the LXE device desktop by double-
clicking on the LXE RF Term icon or clicking Start > Programs >
LXE RF Term from the Start menu.
3. Next, select Session > Configure from the menu to open the Configure
screen.