IntelliTrack WMS – Warehouse Management System - Manual (Page 26)

I NTELLI T RACK WMS RF V 8.1
RF Guide
16
4. At the Configure screen, select the Connection tab to bring this area to
the front.
5. In the Host Type section of the screen, select VT220 to be the Host
type.
6. Next, enter the Host IP Address (i.e., the address of the computer run-
ning the RF server) in the Host Address field.
7. In the Terminal Device field, click the drop-down arrow and select
VT100 from the list that appears.
8. In the Telnet Port field, the setting should be 23 (the default setting). If
the setting is another number, enter 23 in this field.
9. Next, tap the VT Config button. The VT Configuration dialog box
opens.
10. Click the Modes tab to bring this tab to the front. Check the Local
Echo check box found in the bottom right corner of the screen.
11. Next, click the Options tab to bring this tab to the front.
12. Click the drop-down arrow in the Send field and select Line Buffered
from the list that appears.
13. Click the OK button in the top right corner of the screen to close the
VT Configuration dialog box. You are returned to the Configure
Screen. (Note that clicking the X icon in the top right corner of the
screen will close the VT Configuration dialog box and cancel all
changes made on that screen.)
14. In the Configure Screen, tap the FNKeys tab to bring this tab to the
front. [Tap the right arrow (>) at the top right edge of the screen twice
to display the FNKeys tab.] The Function key mappings appear.
15. Map Function Keys F1 through F10, according to the values listed in
the table below:
TABLE 1. LXE Terminal Function Key Values
Function Key Value
F1 ^[OP^M
F2 ^[OQ^M
F3 ^[OR^M
F4 ^[OS^M
F5 ^[OM^M
F6 ^[[17^M
F7 ^[[18^M
F8 ^[[19^M