Yokogawa RotaMASS 3-Series - Manual (Page 17)

2. TrANSpOrTATION ANd STOrAgE
2-1
IM 01R04B04-00E-E 8th edition March 01, 2011 -00 All Rights Reserved. Copyright © 2003, Rota Yokogawa
2. TrANSpOrTATION ANd STOrAgE
Transport instructions
When transporting the instrument, you must observe the following safety instructions in order to avoid lethal
injury, damage to the instrument and other material damage.
The steps involved in transport may only be carried out by qualified persons taking into
account the safety instructions.
• Observe the transport instructions on the packaging.
• Observe the below mentioned storage conditions.
• Use only the original packaging.
• The packaging material must be disposed of in accordance with the regulations.
• The transport braces must not be removed until installation.
• Read the chapter “Safety instructions”.
• To avoid any damages, unpack the flowmeter only at the installation site.
• Mechanical shocks are to be avoided.
ROTAMASS is a heavy instrument. Please be careful to prevent persons from injuring
when it is handled.
Storage conditions
Please note the following for storage purposes :
The detector and converter should be stored in its transport packaging.
Choose a storage place that meets the following requirements:
• Protection from rain and humidity
• Free of mechanical vibration and shocks
• Ambient temperature between -40°C to 55°C (RCCT3 / RCCF31 / RCCR31)
-50°C to 80°C (RCCS3)
• Atmospheric humidity ranging from 0 to 100%. Operation above 95% for longer times is not recommended
Before storing a used flowmeter remove any fluid from the flowmeter line completely.
Properties of the instrument can change when stored outdoors.
WARNING