Yokogawa IR400 - Manual (Page 62)

6 - 23
IM 11G02N01-01E
6.5.2.2 Forced stop of auto zero calibration
This mode is used to cancel the auto zero calibration forcedly.
(1) In the User mode that is displayed, point
the cursor to “Setting of Auto Zero
Calibration” by pressing the
or
key. Press the
ENT
key.
(2) In the “Setting of Auto Zero Calibration”
item selection screen that appears, point
the cursor to “Auto Zero Calibration
Stop” by pressing the
or key.
Press the
ENT
key.
(“Auto Zero Calibration Stop” appears
when the screen is selected while auto
zero calibration is performed.)
(3) “Stop” is inverted. A message appears,
prompting you to verify that you want to
stop auto zero calibration. Press the
ENT
key to stop the auto zoro calibration
forcibly, and the
ESC
key to cancel (not
stopped).
( )
ENT
( )
ENT