SilentKnight VisorAlarm ARLY Interface - Manual (Page 13)

VISOR ALARM – ARLY Configuration
II - 8
Doc.DM359-I
Rev.2.0
2. Command set
ARLY-1 Cfg>?
alarm-receiver Alarm Receiver emulation params
automation-software-required Specify if automation SW is required to
return kissoffs
backup-alarm-receiver Set parameters for network backup
cfg-pattern Config pattern params
description Enter interface description
io-conf Configure the general purpose I/O
list List all config params
log Save/clear SRAM events log
mip MIP configuration params
monitor-ip-addr Internet IP addr to check availavility
no Negates a command or sets its defaults
printable-events Events to be sent to a serial printer device
priority-standard Priority standard used to display signals
serial-parameters Asyncronous serial line params
set
shutdown Change state to administratively down
sms SMS receiving params
supervision MIP supervision params
update Update remote MIP's config
user-defined-events Set codes for user defined events
exit
2.1. ALARM-RECEIVER
Specifies the emulated alarms receiver and permits you to configure the related parameters.
Syntax:
ARLY-1 Cfg>ALARM-RECEIVER <parameter, values>
protocol alarm receiver emulation protocol
receiver-id receciver id for Sw Automation
line-id line id for Sw Automation
link-test-timer link test timer
parameters additional parameters
block type of alams to be blocked
a) ALARM-RECEIVER PROTOCOL
Configures the type of alarms receiver going to be emulated. A Sur-Gard receiver, a Radionics 6500
receiver and an Ademco 685 receiver can be emulated. Emulation for the Sur-Gard receiver adjusts to
the MLR2000/MLR2E v1.2 specification. Default is Sur-Gard receiver emulation.
Syntax:
ARLY-1 Cfg>ALARM-RECEIVER PROTOCOL protocol
ademco-685
radionics-6500
sur-gard
Example:
ARLY-1 Cfg>ALARM-RECEIVER PROTOCOL RADIONICS-6500
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command: