SilentKnight VisorAlarm ARLY Interface - Manual (Page 67)

VISOR ALARM – ARLY Configuration
II - 62
Doc.DM359-I
Rev.2.0
ARLY-1 Cfg>NO USER-DEFINED-EVENTS COMMUNICATION-FAILURE <code>
e) USER-DEFINED-EVENTS CONFIG-ERR
Permits you to configure an event code to be sent in the alarm generated by the backup VisorALARM
when a configuration problem is detected in an mIP/IPDACT as the backup VisorALARM receives
polls from an mIP/IPDACT that has not switched to backup. Default value for this parameter is 395.
Syntax:
ARLY-1 Cfg>USER-DEFINED-EVENTS CONFIG-ERR <code>
ARLY-1 Cfg>
Example:
ARLY-1 Cfg>USER-DEFINED-EVENTS CONFIG-ERR 395
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO USER-DEFINED-EVENTS CONFIG-ERR <code>
f) USER-DEFINED-EVENTS DOWN-CTIVE-STATE
Permits you to configure an event code to be sent in the alarm generated both by the main and the
backup VisorALARM when this changes its state from active to down, i.e. when communications
failure has been detected. Default value for this parameter is 396 for the primary VisorALARM and
398 for the secondary.
Syntax:
ARLY-1 Cfg>USER-DEFINED-EVENTS DOWN-ACTIVE-STATE <code>
Example:
ARLY-1 Cfg>USER-DEFINED-EVENTS DOWN-ACTIVE-STATE 396
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO USER-DEFINED-EVENTS DOWN-ACTIVE-STATE <code>
g) USER-DEFINED-EVENTS PRIMARY-DOWN
Permits you to configure an event code to be sent in the alarm generated both by the backup
VisorALARM when this is in backup mode. Default value for this parameter is 399.
Syntax:
ARLY-1 Cfg>USER-DEFINED-EVENTS PRIMARY-DOWN <code>
Example:
ARLY-1 Cfg>USER-DEFINED-EVENTS PRIMARY-DOWN 399
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.