SilentKnight VisorAlarm ARLY Interface - Manual (Page 73)

VISOR ALARM – ARLY Configuration
II - 68
Doc.DM359-I
Rev.2.0
ARLY-1 Cfg>USER-DEFINED-EVENTS LOG-50LOAD 622
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO USER-DEFINED-EVENTS LOG-50LOAD <code>
w) USER-DEFINED-EVENTS LOG-90LOAD
Permits you to configure the event code to be sent in the alarm generated by the VisorALARM when
the SRAM events log is detected to have loaded to 90 % of its current total capacity. By default the
alarm code is 623 (event log 90% full).
Syntax:
ARLY-1 Cfg>USER-DEFINED-EVENTS LOG-90LOAD <code>
ARLY-1 Cfg>
Example:
ARLY-1 Cfg>USER-DEFINED-EVENTS LOG-90LOAD 623
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO USER-DEFINED-EVENTS LOG-90LOAD <code>
x) USER-DEFINED-EVENTS LOG-OVERFLOW
Permits you to configure the event code to be sent in the alarm generated by the VisorALARM when
this detects an overflow at the SRAM events log. By default the alarm code is 624 (event log
overflow).
Syntax:
ARLY-1 Cfg>USER-DEFINED-EVENTS LOG-OVERFLOW <code>
ARLY-1 Cfg>
Example:
ARLY-1 Cfg>USER-DEFINED-EVENTS LOG-OVERFLOW 624
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO USER-DEFINED-EVENTS LOG-OVERFLOW <code>
y) USER-DEFINED-EVENTS LOG-SAVE
Permits you to configure the event code to be sent in the alarm generated by the VisorALARM when
the SRAM events log is saved to a file by a user (execution of command “log save” in the ARLY
interface menu). By default the alarm code is 655.
Syntax:
ARLY-1 Cfg>USER-DEFINED-EVENTS LOG-SAVE <code>
ARLY-1 Cfg>
Example:
ARLY-1 Cfg>USER-DEFINED-EVENTS LOG-SAVE 655
ARLY-1 Cfg>