SilentKnight VisorAlarm ARLY Interface - Manual (Page 86)

VISOR ALARM – ARLY Monitoring
IV - 81
Doc.DM359-I
Rev.2.0
Alarms lost: 0
ARLY-1+
b) LIST INTERFACE-STATISTICS
Displays statistics relative to the transmitting and receiving of data through the serial interface. These
statistics can be deleted through the monitoring command CLEAR INTERFACE-STATISTICS.
Syntax:
ARLY-1+LIST INTERFACE-STATISTICS
Example:
ARLY-1+LIST INTERFACE-STATISTICS
Interface statistics:
---------------------
Device status: ABSENT
Tx frames: 0 Rx frames: 0
Tx bytes: 0 Rx bytes: 0
ARLY-1+
c) LIST MIP
Displays information and statistics on the mIP/IPDACTs registered in the VisorALARM.
Syntax:
ARLY-1+LIST MIP ?
INFORMATION
STATISTICS
STATUS
ALL
• LIST MIP INFORMATION
Displays all known information on one or all the supervised mIP/IPDACTs. The command requests
an mIP/IPDACT account number to execute the operation. The account number is composed of one
to 8 hexadecimal digits (0 to 9 and letters A to F). If the account number is FFFFFFFF, information
on all the supervised mIP/IPDACTs is displayed.
The information shows the mIP/IPDACT account number, the state of this due to supervision, its
serial number and software version, configuration data and data relative to the UDP connection.
From the VisorALARM point of view, the mIP/IPDACT can adopt various states:
alive
A keep-alive frame has been received from the mIP/IPDACT indicating that the
connection is operative. The connection is active.
clr Temporary state the mIP/IPDACT enters to check that keep-alive traffic is being
received. The connection is considered active. If the supervision timer times out
and the mIP/IPDACT state has not passed to alive, the connection is considered
lost and passes to a lost state.
lss-sgn The configured supervision time has timed out and a keep-alive frame has not been
received from the mIP/IPDACT. The connection is considered lost.
rgstr State taken by an mIP/IPDACT after the VisorALARM has started up. The
connection is not considered active. It is considered active once the mIP/IPDACT
has sent keep-alive traffic. If the supervision period times out without receiving
any frame from the mIP/IPDACT, the connection is considered lost.
cnt A contact frame has been received from the mIP/IPDACT. Until a keep-alive
frame has been received, the connection cannot be considered active. If the