SilentKnight VisorAlarm ARLY Interface - Manual (Page 89)

VISOR ALARM – ARLY Monitoring
IV - 84
Doc.DM359-I
Rev.2.0
f) LIST PROTOCOL
Displays statistics relative to the protocol used by the mIP/IPDACTs and the VisorALARM to
exchange information. Within these statistics both the sent frames as well as the received frames and
within the latter those received correctly, those received with error etc., are counted and displayed.
Syntax:
ARLY-1+ LIST PROTOCOL
Example:
ARLY-1+LIST PROTOCOL
MIP Protocol statistics:
-----------------------
Rx RSrvc frm: 834 Rx RAlarm frm: 0
Rx RSrvc error frm: 0 Rx RAlarm error frm: 0
Rx RSrvc accnt error frm: 0 Rx RAlarm accnt error frm: 0
Rx Contact frm: 3 Rx Kplv frm: 831
Rx Contact error frm: 0 Rx Kplv error frm: 0
Tx RCnfg frm: 0 Rx RReg frm: 0
Rx RCnfg Rsp frm: 0 Rx RReg drop frm: 0
Rx RCnfg OK rsp frm: 0 Rx RReg OK frm: 0
Rx RCnfg NO OK rsp frm: 0 Rx RReg error frm: 0
Rx RCnfg error Rsp frm: 0
Rx RCnfg s/n error Rsp frm: 0
ARLY-1+
g) LIST SMS
Monitors the parameters relative to alarm reception through SMS messages.
These commands are only applied if you have a GPRS/GSM card for alarm reception through SMS
messages.
For further information, please see manual DM 322-I “VisorALARM: Alarm Reception through
SMS”.
h) LIST UDP-STATISTICS
Displays statistics relative to the transmitting and receiving of data through the UDP port configured
for the ARLY interface. These statistics can be deleted through the CLEAR PROTOCOL command.
Syntax:
ARLY-1+LIST UDP-STATISTICS
Example:
ARLY-1+LIST UDP-STATISTICS
UDP statistics:
---------------
Tx frames: 795 Rx frames: 795
Tx bytes: 22260 Rx bytes: 25584
ARLY-1+
i) LIST VISORALARM-STATE
Displays the statistics relative to the device state, the date when the last configuration synchronization
took place and in cases of devices configured as backup, the accumulated time the device has been in
BACKUP mode.
ƒ Case of a main VisorALARM