SilentKnight VisorAlarm ARLY Interface - Manual (Page 65)

VISOR ALARM – ARLY Configuration
II - 60
Doc.DM359-I
Rev.2.0
mip-registration event code to send when a mip registers
mip-loss event code to send when a mip stop sending
keepalives
network-failure event code to send when the alarm receiver
loss network connectivity
communication-failure event code to send when the backup
alarm-receiver is in standby and it has
received keepalives from a backed-up MIP
config-err event code to send when the backup
alarm-receiver is in standby and it has
received keepalives from a MIP
down-active-state event code to send when the alarm receiver has
changed from active to down state.
primary-down event code to send when the backup alarm
receiver has detected that primary alarm
receiver is down.
backup-down event code to send when the primary alarm
receiver has detected that backup alarm
receiver is down.
available-roomFull event code to send when the alarm receiver has
no room to store alarms.
input-changed event code to send when a input mip has
changed.
input-sensor-trouble event code to send when a input sensor trouble
is detected.
tamper event code to send when a tamper open/close
detected.
PTSN-failure event code to send when a failure in the PTSN
line is detected.
MIP-changed event code to send when a registered MIP has
changed its Serial Number.
icmp-poll-failure event code to send when a ICMP polled device
fails to respond.
Hdw-fault event code to send when a supervised hardware
element faults.
MIP-HW-Failure event code to send when a HW fault is
detected.
visoralarm-time-inaccurate event code to send when the NTP protocol is
unable.
ac-loss event code to send when the AC power supply is
lost.
low-battery event code to send when the load of the system
battery is low.
log-clear event code to send when the log is cleared.
log-50load event code to send when the log is 50% loaded.
log-90load event code to send when the log is 90% loaded.
log-overflow event code to send when the log is overflowed.
log-save event code to send when the log is saved to file.
a) USER-DEFINED-EVENTS MIP-REGISTRATION
Permits you to configure the event code to be sent in the generated alarm when a new mIP/IPDACT
registration is received. Default value for this parameter is 633 (Module Added event).
Syntax:
ARLY-1 Cfg>USER-DEFINED-EVENTS MIP-REGISTRATION <code>
ARLY-1 Cfg>
Example:
ARLY-1 Cfg>USER-DEFINED-EVENTS MIP-REGISTRATION 532
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command: