SilentKnight VisorAlarm ARLY Interface - Manual (Page 76)

VISOR ALARM – SEPI Configuration
III - 71
Doc.DM359-I
Rev.2.0
1. Initial Configuration
So that the printable events defined in the ARLY interface can be sent to a serial printing device with
ASCII format, you need to configure an SEPI interface over one of the serial inputs in the device. The
SEPI interface configuration is carried out as follows:
Syntax:
*p 4
Config>set data-link serial0/X
Config>save yes
The X value corresponds to the VisorALARM serial interface number and must be different to that
used in the ARLY net.
Once the configuration has been saved, you need to restart the device to activate the new interface.
Once you have restarted, you can check that the operation has been correctly executed by displaying
all the device configuration or by displaying the status of the configured interfaces:
Config>show conf
; Showing System Configuration ...
; Visor Alarm Router 2 16 Version 10.5.9.0.2
log-command-errors
no configuration
description "Default configuration: VisorALARM standard"
set data-link arly serial0/0
set data-link sepi serial0/1
set data-link x25 serial0/2
cfg-mode binary
;
network serial0/2
; -- SEPI Interface Configuration --
exit
;
exit
;
dump-command-errors
end
; --- end ---
Config>list device
Interface Connector Type of interface
ethernet0/0 LAN1 Fast Ethernet interface
serial0/0 SERIAL0/WAN1 ARLY Async Line
serial0/1 SERIAL1/WAN2 Serial Event Printer Interface
serial0/2 SERIAL2/WAN3 X25
x25-node --- Router->Node
Config>
How to check, in both cases, that the serial line serial0/1 has been configured as an SEPI interface.
To access the SEPI interface configuration, use the NETWORK command and the serial line
associated to the SEPI interface:
Config>NET serial0/1
-- SEPI Interface Configuration --
BACKUP SEPI-serial0/1 Cfg>
From this menu you can configure the serial line parameters to connect to the printer serial device.