SilentKnight VisorAlarm ARLY Interface - Manual (Page 68)

VISOR ALARM – ARLY Configuration
II - 63
Doc.DM359-I
Rev.2.0
ARLY-1 Cfg>NO USER-DEFINED-EVENTS PRIMARY-DOWN <code>
h) USER-DEFINED-EVENTS BACKUP-DOWN
Permits you to configure an event code to be sent in the alarm generated both by the main
VisorALARM when while not having communication failure, a situation where this is not being
polled by the backup device has been detected. Default value for this parameter is 358.
Syntax:
ARLY-1 Cfg>USER-DEFINED-EVENTS BACKUP-DOWN <code>
Example:
ARLY-1 Cfg>USER-DEFINED-EVENTS BACKUP-DOWN 358
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO USER-DEFINED-EVENTS BACKUP-DOWN <code>
i) USER-DEFINED-EVENTS AVAILABLE-ROOMFULL
Permits you to configure an event code to be sent in the alarm generated by the VisorALARM
when it can not store more signals. Default value for this parameter is 393.
Sintaxis:
ARLY-1 Cfg>USER-DEFINED-EVENTS AVAILABLE-ROOMFULL <código>
ARLY-1 Cfg>
Ejemplo:
ARLY-1 Cfg>USER-DEFINED-EVENTS AVAILABLE-ROOMFULL 690
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO USER-DEFINED-EVENTS AVAILABLE-ROOMFULL <código>
j) USER-DEFINED-EVENTS INPUT-CHANGED
Permits you to configure an event code to be sent in the alarm generated by the VisorALARM when a
change in the input status alarm is received from the mIP/IPDACT. By default the alarm code is 110
(fire alarm).
Syntax:
ARLY-1 Cfg>USER-DEFINED-EVENTS INPUT-CHANGED <code>
Example:
ARLY-1 Cfg>USER-DEFINED-EVENTS INPUT-CHANGED 112
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.