SilentKnight VisorAlarm ARLY Interface - Manual (Page 82)

VISOR ALARM – ARLY Monitoring
IV - 77
Doc.DM359-I
Rev.2.0
1. Monitoring the Serial Interface
Information on the serial device as such can be seen through the monitoring command DEVICE. As
well as showing the number of times the ARLY interface has dropped and reestablished, it also shows
the signal state, configuration for this and the error statistics. In order to obtain a printed version, enter
the following from the monitoring process:
+device serial0/0
Auto-test Auto-test Maintenance
Interface CSR Vect valids failures failures
serial0/0 FA200A00 5e 0 0 0
Interface DCE
V.24 circuits:105 106 107 108 109 125 141
Nicknames: RTS CTS DSR DTR DCD RI LL
State: OFF ON ON OFF ON --- ---
Speed (bps) = 57600
Throughput (bps) = 0
Last throughput (bps) = 0
Bits per character = 7
Stop bits = 2
Parity selected = EVEN
Parity errors = 0
Data errors = 0
Overrun errors = 0
Last reset = 17 minutes 16 seconds
+