SilentKnight VisorAlarm ARLY Interface User Manual

Page 39

Advertising
background image

VISOR ALARM – ARLY Configuration

II - 34

Doc.DM359-I

Rev.2.0

ARLY-1 Cfg> list user-defined-events
User defined event codes:
------------------------
New MIP instalation (register) : 633
MIP loss of contact : 350
VisorALARM network failure : 356
MIP goes to backup mode : 394
MIP sending events to backup VisorALARM : 395
VisorALARM down-active : 396
Primary VisorALARM down : 399
Secondary VisorALARM down : 358
Alarm store occupation reaches 100% : 393
MIP input active/deactive : 110
MIP input sensor trouble : 380
MIP tamper : 383
MIP PSTN Supervision : 351
MIP change detected : 306
VisorALARM supervised hdw fault : 300
MIP HW Failure : 333
VisorALARM time inaccurate : 397
VisorALARM AC loss : 301
VisorALARM low system battery : 302
VisorALARM log cleared : 621
VisorALARM log 50% loaded : 622
VisorALARM log 90% loaded : 623
VisorALARM log overflowed : 624
VisorALARM log saved to file : 655

2.8. LOG

Permits you to monitor and manage the SRAM events log included in a VisorAlarm receiver equiped
with a VA-UD expansion board.
Syntax:

ARLY-1 Cfg>log ?
clear Clear current SRAM signals database
info State of SRAM signal database
save Save current SRAM signal database to file [SRAM_date_time.log]

a) LOG CLEAR
Clear the whole SRAM events log. This command is intended to be used after saving the log to a file.
Only use this command if you are fully aware and understand its reach and consequences.
Syntax:

ARLY-1 Cfg>log clear

Example:

ARLY-1 Cfg>log clear
ARLY-1 Cfg>

b) LOG INFO
Displays information about SRAM events log:

• Total signals. Total number of signals received and stored at the VisorAlarm receiver.

Percentage of SRAM events log memory already occupied.

• Unacknowledged signals. Number of signals pending to be acknowledged by operator at the

VisorAlarm receiver, specifying how many of them relate to system trouble condition type.

• Unrestored signals. Number of signals pending to be restored to normal status at the

VisorAlarm receiver, specifying how many of them relate to system trouble condition type.

Syntax:

Advertising