SilentKnight VisorAlarm ARLY Interface - Manual (Page 28)

VISOR ALARM – ARLY Configuration
II - 23
Doc.DM359-I
Rev.2.0
the mIP/IPDACT when a register is produced, rather it is stored in the mIP/IPDACT local
configuration and is used for local events generated for this account number.
Syntax:
ARLY-1 Cfg>CFG-PATTERN n local-events-zone identifier-zone
identifier-zone This is a hexadecimal number of up to three digits.
Example:
ARLY-1 Cfg>CFG-PATTERN 10 LOCAL-EVENTS-ZONE 015
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO CFG-PATTERN n LOCAL-EVENTS-ZONE identifier-zone
t) CFG-PATTERN n MNT-IP-ADDRESS
This parameter defines the VisorALARM, which receives the maintenance signals, address. A
maintenance alarms receiver permits you to configure the system so trouble signals proceeding from
the mIP/IPDACT devices are received and processed in an alternative location where the said receiver
is situated.
Syntax:
ARLY-1 Cfg>CFG-PATTERN n mnt-ip-address ip-address
ip-address Maintenance VisorALARM IP address.
Example:
ARLY-1 Cfg>CFG-PATTERN 10 MNT-IP-ADDRESS 80.26.96.184
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.
ARLY-1 Cfg>NO CFG-PATTERN n MNT-IP-ADDRESS ip-address
u) CFG-PATTERN n MNT-PASSWORD
Configures the password used by the maintenance VisorALARM to encrypt its messages. This
password may be dependent on the mIP/IPDACT account number, in the same way as before.
Syntax:
ARLY-1 Cfg>CFG-PATTERN n MNT-PASSWORD password
password Password of up to 16 hexadecimal digits (0 to 9, A, B, C, D, E and F).
This also admits letter U, V, W, X, Y and Z.
Example:
ARLY-1 Cfg>CFG-PATTERN 10 MNT-PASSWORD 12XYZ00BZ
ARLY-1 Cfg>
To return to the default configuration for this parameter, use the following command.