HP Designjet 4500 Printer series - Manual (Page 153)

Change the temperature
The stacker contains a heated roller to remove the curl from the paper. To change the temperature of
the roller, select the
icon on the printer's front panel, then Accessories > Stacker > Select
temperature level. There are three options:
● Normal is the default and recommended setting.
● High sets the roller to a higher temperature, which may be useful for particularly stiff paper.
● Low sets the roller to a lower temperature, which may be useful for paper with a particularly
sensitive coating.
Change paper rolls while using the stacker
1. Remove the stack of cut paper from the stacker in order to make the stacker easier to handle.
2. Detach the stacker from the printer: first one side, then the other.
3. Change the rolls in the normal way: see Unload a roll from the printer [4500] and Load a roll into
the printer [4500].
Clean the exterior of the stacker
See Clean the exterior of the printer.
Clean the stacker rollers
WARNING! The stacker becomes hot during use. Before cleaning, switch it off and give it
time to cool.
Ink tends to stick to the main stacker roller and the small output rollers, which should therefore be
cleaned regularly using a fabric cloth dampened with water.
The frequency with which cleaning is needed depends to some extent on the paper type in use.
● For plain, coated, or heavyweight coated paper, once a month may be sufficient.
● For translucent, vellum, glossy, or natural tracing paper, cleaning may be required once a week
even with the slowest print modes.
ENWW Change the temperature 139
How do I... (stacker
topics) [4500]