HP Designjet 4500 Printer series - Manual (Page 53)

13. You should see the front panel message below.
14. Using the stops, carefully wind the excess paper back onto the spindle.
15. Close the printer window.
16. The printer will adjust the paper by winding it back and forth, after which you can expect the
front panel message below.
17. Using the stops, carefully wind the excess paper back onto the spindle.
18. The printer will automatically perform printhead alignment and a color calibration for the paper
type that you have loaded. During this process the printer will advance the paper by up to 3 m
(≈10 ft) before printing. Please do not try to stop the paper advance; it is necessary to ensure a
successful printhead alignment. The whole alignment and calibration process will take about
twenty minutes; while it is going on, you can start connecting the printer. See Connect the printer.
ENWW Load the paper into the printer 39
How do I... (printer
assembly topics) [4000]