HP Designjet 4500 Printer series - Manual (Page 78)

7. Remove the two foam end packs and the plastic covering the printer.
8. Position the left leg cover on the front of the left leg (1), then clip the rear edge (2) into place.
9. Position the right leg cover on the front of the right leg (1), then clip the rear edge (2) into place.
10. Remove the anti-slip material from the two rear wheels on the stand assembly.
64 Chapter 3 How do I... (printer assembly topics) [4500] ENWW
How do I... (printer
assembly topics) [4500]