HP Designjet 4500 Printer series - Manual (Page 250)

The paper cannot be loaded successfully [4000]
NOTE This topic applies to the HP Designjet 4000 Printer series only.
● The paper may be loaded at an angle (skewed or mislocated). Check that the right-hand edge
of the paper is aligned with the half-circle on the right-hand side of the platen and, particularly in
the case of sheet paper, that the leading edge is aligned with the metal bar in the platen.
● The paper may be crumpled or warped, or may have irregular edges.
Rolls
● If the paper gets stuck in the paper path to the platen, it may be that the leading edge of the
paper is not straight or clean, and needs to be trimmed. Remove the initial 2 cm (1 in) from the
roll and try again. This may be necessary even with a new roll of paper.
● Check that the spindle is correctly inserted. The spindle lever on the right should be in the
horizontal position.
● Check that the paper is correctly loaded on the spindle, and that it loads over the roll towards
you.
● Check that the paper is wound tightly on the roll.
Sheets
● Check that the leading edge of the sheet is aligned with the cutter channel in the platen.
● Do not use hand-cut sheets, which may be of irregular shapes. Use only purchased sheets.
Here is a list of front panel messages related to paper loading, with the suggested corrective
action.
Front panel message Suggested action
Right edge of roll too far from load line. The roll has not been loaded correctly, the right–hand edge was not aligned
with the half–circle on the platen. Press the Select key to try to load the roll
again.
Right edge of sheet too far from load
line. The sheet has not been loaded correctly, the right–hand edge was not
aligned with the half-circle on the platen. Press the Select key to try to load
the sheet again.
Right edge not found. The printer cannot locate the right–hand edge of the paper, the paper may
be badly positioned. Press the Select key and try to load the roll again.
Sheet edge not found. The printer cannot locate the edges of the paper, the paper may be badly
positioned. Press the Select key and try to reload the sheet.
Paper not found. During the paper load process the printer did not detect any paper. Press the
Select key to retry.
Paper loaded with too much skew. During the paper load process the printer detected that the paper had too
much skew. Press the Select key to try to load the paper again.
Paper too small. During the load process the printer detected that the paper is too narrow or
too short to be loaded in the printer. Press the Cancel key to stop the load
process. See Functional specifications.
Paper too big During the load process the printer has detected that the paper is either too
wide or too long (sheet only) to be loaded properly. Press the Cancel key to
stop the load process. See Functional specifications.
236 Chapter 17 The problem is... (paper topics) ENWW
The problem is... (paper
topics)